Epoxy Flooring in Delphi, IN

Epoxy flooring in Delphi covers a wider range of buildings than you might expect for a city of about 3,000 people. Delphi was platted in 1828 and became the Carroll County seat a few months later. That long history means we coat floors in older homes and garages, and also in commercial spaces around the courthouse square, where businesses need floors that clean up fast and handle daily traffic.

Commercial floors around the square

The Delphi Courthouse Square Historic District, Delphi City Hall and the Niewerth Building are all listed on the National Register of Historic Places. Older commercial buildings like these often have concrete floors in back rooms, storage areas and basements that have been painted, patched and repainted over the years. Those layers have to come off before a new coating will hold.

For a shop, office or storage room, we usually recommend: 1. Full grinding to remove paint and sealers. 2. Crack and joint repair, with joints honored so the floor can still move. 3. A 100% solids epoxy base for strength and chemical resistance. 4. A topcoat chosen for the use: slip resistance for wet areas, or a harder wear coat for carts and dollies.

We can work around business hours and plan the job in sections so part of the space stays open. If your building is in the historic district and the project touches the exterior, check with the city on that part. A floor coating is interior work.

Homes and garages

Delphi's 2020 census count was 2,961 people in 1,182 households. Many of the homes are on established streets with garages that have seen decades of use. A typical older Delphi garage floor shows a few of these:

• Oil stains that have soaked deep into the concrete.
• Cracks running across the slab from settling.
• Scaling near the door where salty slush sits each winter.
• Old garage floor paint lifting in the tire paths.

Grinding removes the weak top layer, and our crack and floor repair work fills what is left. A flake epoxy or polyaspartic system then seals the surface so winter slush stays on top.

Get a Free Estimate

Basements in town

Delphi homes with basements get the same moisture test we run everywhere. A basement floor coating makes a laundry room or storage area brighter and easier to sweep, but it cannot fix water that comes through the slab. If the reading is high, we tell you before quoting a system.

Close to Lafayette

Delphi sits about twenty minutes northeast of Lafayette and is part of the Lafayette metro area. That makes it an easy trip for estimates, and it means we can schedule Delphi jobs on the same calendar as our Lafayette work without long waits.

Choosing a finish for a Delphi floor

Owners here tend to ask about three looks:

• Full flake: the most forgiving for garages, since it hides dust and salt film.
• Solid color with light flake: a cleaner look for basements and commercial back rooms.
• Clear sealed concrete with a polyaspartic topcoat: for owners who like the look of the existing slab after grinding.

We bring sample boards to the estimate so you can see each one under your own lights. The written quote names the system, the number of coats and the prep for each area, so a homeowner or a business owner can compare options side by side.

The threshold strip

The strip just inside a garage door takes the most slush and salt, so it is often the first place an older Delphi slab scales. We grind out the loose concrete there, rebuild it with a patching mortar and grind it level before coating.